Picture for illustrative purposes only
High Resolution Infrared See-in-the-Dark Night Vision Colour Camera
that addresses shortcomings associated with ordinary Day / Night
Colour Cameras that either do not have an IR-CUT Filter or have a
compromise Notch type IR-CUT Filter.
This Camera has an automatic mechanically movable traditional
Infrared Cut Filter for Vivid Colour Rendition & maximum low light &
J Panasonic CCD.
J ~ 700 H-Pixels.
~ 0.5 Lux.
48 + dB Signal : Noise Ratio.
Day Night Security Camera
HIGH 700 + H-Pixel SEE-in-the-DARK
21 IR LED Colour Day
/ Night Infrared Night Vision Video Camera with Motorised movable
IR Cut Filter *
inbuilt Infra-Red LED illuminator * ⅓"
D4 PANASONIC CCD * Wall / Ceiling Swivel / Tilt Mounting Bracket.
This Camera is ideal for most common
Surveillance applications and for 'disturbance-free' observation (in total
darkness) of Babies, Convalescing, Birds, Animals, etc., while Sleeping,
Recuperating, Nesting, Calving, etc.
Suitable for average to zero
illumination levels in Homes, Shops, Showrooms, Offices, Warehouses,
sheltered, shaded & evenly lit outdoor use under eaves, etc.
DIY Plug-In installation when purchased
REG12/1.0A Plug Pack.
|No optional Lenses for this Camera
|All values are
|Width of Vision
with 4 mm Lens fitted to Camera |
|6 m |
IP Surveillance Cameras
System fully compatible with Australian TV System.
753 (H) x 582 (V) 438
246 Pixel ⅓" D4 PANASONIC Interline Transfer
CCD Sensor, due to the sensitive nature of the chip manufacturing process there
may be more imperfections in the photodiodes in this Special CCD Image Sensor
than in an ordinary sensor, Security
Lens: Board Type 4 mm Focal Length,
there are no Accessory Lenses for this Camera,
Scanning System: 2 : 1
Interlace PAL 50 Hz vertical, 15 625 Hz horizontal.
Video Output: 1.14 V
p-p Composite Video 75 ohms, suit Australian TV, VCR, AV & Video inputs, BNC
socket on ~ 30 cm cable.
Horizontal Pixels: 700
+ (this value is provided for comparative purposes only) Better than VHS &
better than Super-VHS resolution.
Sensitivity: ~ 0.5 lux
@ F1.2 (this value is provided for comparative purposes only), 0 lux with LEDs
'ON'. The Infrared LEDs illuminate ~ 95% of the Width-of-Vision and are
effective up to approximately 15 m depending on the reflective characteristics
Light Emitting Diodes:
Twenty One ~ 850 nm wavelength Infrared, these produce a dull Red visible glow.
Automatic Light Sensor switches LEDs On/Off depending on light level.
Movable Infrared Optical Filter:
In Day mode (well lit, colour) mechanism automatically
positions IR-CUT optical filter between Lens and Image Sensor to exclude
Infrared radiation that would otherwise adversely affect colour reproduction,
this ensures colour rendition not possible with ordinary
non-filtered or notch-filter type Day/Night cameras.
In Night mode (low light, monochrome) mechanism
automatically removes IR-CUT optical filter to allow Infrared radiation to pass
boosting low light and Infrared sensitivity, the result is significantly better
night images using inbuilt
Infrared Illuminator or with Infrared rich light sources.
Infrared Response without Infrared filter is ~
700 to ~ 1100 nm better
notch IR Filter', additional
CCTV Infrared Night Vision information.
Switch-Over: Colour to Monochrome ~ 3 Lux, Monochrome to Colour ~ 5 Lux.
Shutter (AES): 1/50 to 1/100 000 second, 20 milliseconds to 10 microseconds,
Automatic Gain Control:
~ 400 to ~ 1100 nm with Infrared 'CUT' Filter
'out' of optical path, additional
CCTV Infrared Night Vision information.
Signal to Noise ratio:
48 + dB, measured with AGC off.
Power Requirements: 12
Volts DC Regulated, ~ 400 milliamps with LEDs On, 2.1 x 5.5 mm DC socket, center
pin = (+), ~ 30 cm
Dimensions: ~ 75 mm
Diameter, ~ 115 mm Long including cable Union, ~ 460 grams. Hood ~ 150 mm Long,
~ 80 mm Wide, ~ 85 grams.
Made in Taiwan in an
ISO 9001 certified factory.
Experience: 30 + Years.
Day Night Colour Infrared Light Emitting Diode (Night Vision) Cameras
Colour CCTV Day Night Cameras with
inbuilt Infrared Light Emitting Diodes "See-in-the-Dark" and produce images
when visible illumination is zero.
At average levels of illumination
these Cameras produce Colour images, depending on their sensitivity (Lux) at
low illumination levels and in total darkness the image is Monochrome.
These Cameras generally have a
relatively high sensitivity image sensor and
Fixed Iris Lens
therefore under high illumination levels images will be overexposed for the
here, an exception is
MINI-COL-IR which has a special Wide Dynamic Range allowing it to cope
with higher illumination levels than ordinary Cameras.
Ordinary CCTV Colour Cameras are
relatively insensitive to Infrared because they have an IR CUT Filter
between the Lens and Image Sensor, this filter excludes Infrared radiation
with a wavelength greater than ~ 700 nm that would otherwise adversely
affect White Balance, Colour Rendition and Image Sharpness.
Day / Night Colour CCTV Cameras are
sensitive to Infrared because they either do not have an IR CUT Filter or
utilise a special NOTCH IR CUT Filter that excludes the wavelengths most
harmful to colour quality (720 ~ 830 nm) from reaching the Image Sensor.
A Colour Camera that does not have
an IR CUT Filter usually has poor
colour rendition characterised by a Pink-Red
'tint' when the illumination is InfraRed rich, use of
a 'Notch' Filter helps however White Balance, Colour Rendition and Image
Sharpness are compromised for Infrared sensitivity. (Image Sharpness can be
restored by using a specially designed Lens that corrects the focus shift
between Visible and Infrared)
The IDEAL Day / Night Infrared
Sensitive Colour CCTV Camera would utilise an
Automatic Iris Lens to cope with high illumination levels and the Lens
would also have a large aperture (low 'F' number) to maximise light
transmission when illumination levels are low * it would also utilise a
Traditional IR CUT Filter when illumination levels are adequate for Colour
and then REMOVE the IR CUT Filter when levels are low
CCS-IRdnWD have these features and are recommended
for OPTIMUM results - the ULTIMATE SOLUTION is
DomePTZ-dn these also have Automatic-Focus to
ensure crisp images under all conditions.
Infrared rich light sources include
Daylight and most Filament type lamps including common Spot lamps, Tungsten
lamps, Halogen lamps, etc.
The majority of Light emitted from
'Cold' type sources such as Fluorescent, Mercury Vapour, Sodium Vapour,
etc., is visible, these sources contain little Infrared energy.
Infrared capability is a trade-off that affects Colour Quality particularly
in "Infrared Rich" environments.
Resolution Mini Colour Infrared Night Vision Video Camera Day Night CCTV Video
Surveillance Infrared Camera, High Sensitivity SEE in the DARK with Infrared
LED, LOW BLEMISH Panasonic CCD Image Sensor. Suitable for average to zero light
levels in Homes, Offices, Showrooms etc. Night Vision Camera using Infrared
Light Emitting Diodes. Ideal for discreet surveillance, Board lens for sharper
focus & better results in low light & with InfraRed Illumination. Suitable for
Aviary Nesting Box, Animal & general CCTV Video Monitoring, Security & many
other Closed Circuit Television applications.