Security CCTV |
![]()
|
CCTV |
![]() |
Covert Wireless Pinhole Colour Video Camera with Ant-SMB Antenna inbuilt 4 Channel 2.4 GHz Video Transmitter.Fully self contained only requires Power Supply.[REG12/0.3A] Plug Pack $12[Batt-11V] Battery Pack - 22 Watt RechargeableChoose a Swivel Mounting Bracket $8 |
Applications
Suitable for portable discreet / covert surveillance with virtually unlimited Monitoring / Recording locations using multiple Receivers.
Business: Observe showrooms,
warehouse, offices, doors, etc without the need to install expensive and
inflexible wiring.
Safety: See who is outside your door -
use your TV as a monitor * Monitor your baby, your children, the swimming pool,
the elderly, ill or disabled * Monitor your home with up to four cameras.
Specifications:
CAMERA
Colour CCTV Video Camera with Pinhole Lens - PAL TV system.
Image
Sensor: 1/4 inch
LOW BLEMISH CCD, 512 x 582 pixels.
Lens: Pinhole Type 5.5 mm Focal Length, there
are no Accessory Lenses for this Camera,
additional information
here.
Sensitivity: ~ 3 lux @ F1.2 (this value is provided for comparative purposes only).
Signal : Noise Ratio ~ 48 dB.
Resolution: ~ 440 Horizontal Pixels (this value is provided for comparative purposes only).
Automatic Electronic Shutter: 1/50 ~ 1/100 000 second, 20 ms ~ 10 microseconds,
additional information
here.
TRANSMITTER
ISM Band: 2.4 ~ 2.483 GHz 4 Channel.
Modulation Method: FM.
Oscillator: P.L.L. (Phase Locked Loop).
RF Output Power: 10 mW EIRP (maximum allowed) with 3 dBi Mini Antenna, 50 ohms
impedance, SMB RF connector.
Channel Select (DIP Switch) info:
here
Power Supply Requirements:
12 VDC Regulated, 2.1 mm x 5.5
mm socket, center pin = (+),
Current: ~ 160 mA.
Dimensions:
~ 69 mm (L), ~ 32 (W), ~ 28 mm (H),
excluding antenna. Antenna ~ 62 mm long, ~ 6 mm diameter. Total weight ~ 60
grams.
Compatibility:
Receive signals with
RX-Mon7 &
RX-Mini.
RANGE
Depends on Surroundings,
Obstructions, other Transmitters (2.4 GHz Cordless Phones, Wireless LAN, etc),
Antenna Alignment, Electromagnetic & Radio Frequency interference in the
vicinity. This device may be affected by and may affect other devices that
operate on or near the same frequency causing minor to severe interference.
In ideal, clear,
Line-of-Sight conditions with Vertical 3 dBi Whip antenna on TX
Vertical 5 dBi Whip
antenna on Receiver up to ~ 100 metres.

Correctly matched and
aligned 24 dBi antenna on Receiver up to ~ 1000 metres.

Due to the nature of Radio Signals results are unpredictable (in the same manner as Mobile / Cellular Telephones) signals reflected from surrounding objects arriving at Receiver antenna may Add-to or Subtract-from the direct signal from Transmitter. Directional antennas may reduce affect of reflected signals.
ANTENNAS for RECEIVER not suitable for TX-CAM2p
Range and Signal to Noise
Ratio (SNR) may be improved by increasing gain of antenna on Receiver and/or
Transmitter (in Australia TX may only be fitted with 3 dBi antenna). For
maximum signal transfer TX and RX antennas should be the same polarity, that is
both oriented Vertically or Horizontally.
|
|
|
|
|
|
** Information
plagiarised from this page may be found on 'copy-cat' Web Sites **
Use your Browser "Back
Button" to return to previous page